Note: Our pocket door hardware has a
blue marking on one hinge mounting plate. This mark should always be mounted at
the top of the case. This allows us to distinguish between a left or a right
1. SLIDE POSITIONING
Face Frame applications: The front
of the slides will be pulled up against the back of the face frame.
Panel End Applications: The front of slides
will be fastened to the position of the back of the door in its closed position.
For both applications: The pocket door
should be centered in the case opening in exact relationship as the center to
center of the hinges. (the measurement from the top of the door to the center of
the top hinge should be the same as the measurement from the top of the case
opening to the center of the top slide)
Step #1: Fasten top slide parallel to the
top of case completely using only the round screw holes on slide (for best
result use a #6 pan or truss head screw).
Step #2: Using top slide as a guide, pull
the follow strip all the way to the front of case and back off just enough to
insert screw in the bottom half of the first hole, straight in. Push the follow
strip all the way to the back of case, and install screw in the center the
second round hole, about 1/3 of the way back from the front of the slide. Pull
follow strip forward just enough to install screw in the center of the back
FOR 3-SLIDE SYSTEMS:
Step #1: Install top and bottom slide as you
would with a 2 slide system.
Step #2: Use the follow strip as a guide.
Pull the follow strip all the way forward in the case and push back just enough
to put screw in center of first round hole. Then slide bar all the way to the
back of the case and install screw in the center of the second round hole, about
1/3 of the way back from the front of the slide. Pull follow strip forward just
enough to install screw in the center of the back hole.